CHARGING BASICS 107: Reason why some rapid chargers cutoff at 90% SoC | Is it to prevent battery life degradation?

tesla_model_3_charging

You might have noticed that a few DC rapid chargers cut-off their charging at 95%; some even at 90%. Why do they so? Will the electric vehicles’ battery damage if you let them to rapid charge up to 100%?.

The simple answer is : No, not all! It is just a speculation amongst EV drivers that this limit has been set because it might be bad for the battery to charge it up to 100 percent. 

Then why do some rapid chargers charge only up to 90% of the state of battery and cut-off? This article may help you to understand the reasoning behind.


The reason is common sense & business; not technical!

When you connect an electric vehicle at a rapid charger, it will usually takes on a high charging power up to about 70-80%; after which the charging power starts to drastically taper-off to lower levels, as low as a normal destination AC charging station at home/office.

So, even if you’ve connected to a rapid charger, the EV will charge only at around 20 kW speed after certain percentage of battery SoC (state-of-battery). So some intelligent charge point operators cut-off power at these limits, so that they can free-up the charger for someone else who really need rapid charging.

For example, let’s take a look at the charging curve of Audi e-tron Quattro 50 (P.C: Fastned).

audi-e-tron-charging-rate-curve
 
In the charge curve above, you can see that the EV charges around 150 kW until it reaches 80% of battery SoC (within 20 minutes); from that point the charging speed drastically reduces and takes approximately another 15 minutes to reach 100% state of charge.

It takes about the same amount of time to charge from empty to 80% SOC than it does to charge from 80 to 100% SOC. With that, the EV driver might as well use a destination charge point after this point. Consequently it doesn’t make sense to continue a charge all the way to a 100% because it's a waste of everyone's time including anyone else waiting to use the rapid charger and crucially yours.

It's also worth highlighting that plug-in hybrids (PHEVs) capable of rapid charging such as Mitsubishi Outlander therefore should only stick to destination charge points, thus freeing up rapid chargers for EV drivers in a hurry.


What happens if you still charge upto 100%? Won’t it affect the battery?

Theoretically speaking, yes,  it is never a good idea to charge any battery up to 100%, as it may impact the life of the battery. Lithium-ion batteries do not like being held at high voltages for long periods of time so this will accelerate their degradation; and I would always recommend 80% as the maximum range.

However, the modern battery management systems (BMS) in the newer electric vehicles do a trick to handle this issue. Most of the modern EVs have SoC buffers at high & lower limits, whereby they keep some of the cell's true capacity in reserve and never use the upper SOC buffer to prevent the cells from being overcharged; and the lower SOC buffer prevents degradation due to over discharge.
 
So, when your vehicle’s dashboard tells you that it’s fully charged as 100%, the reality is that the battery pack is probably somewhere in between only 80-90%; same is the case for lower margins as well, when the dashboard shows 0% battery, the actual SoC of the battery would be around 10-20%. Below pictures may explain it well. 

But it is important to note that these upper & lower SoC buffer are not always the same; it changes with the life of the battery. This is the main reason why should not go upto 100%, because in an old EV, when the dashboard shows 100%, the actual SoC could also be close to full – which is not good for the battery. 



Summary:

Charge point operators who stops charging at around 90% are not to be blamed; but to be appreciated. In fact, I would even go further by adding the below additional restrictions.
  • further lower the rapid charge limit to 85% or 90%.
  • introduce over stay penalties for anyone who leaves their car plugged in when is finished charging
  • ban plug-in hybrids (PHEV) from using rapid chargers since they can't make anywhere near full use of them.
  • In addition, I'd have at least one destination post at any site containing a rapid charger which could be used by PHEVs, small BEVs or EVs that genuinely need to charge to 100% SOC.
Charging infrastructure needs are constantly growing; and is impractical to keep adding rapid chargers; If we (EV drivers) adhere to basic rules such as above, everyone can utilize the available rapid charger infrastructure efficiently. 

10 comments:

  1. Can you prove that Fastned is indeed doing this? It seems more likely that the car is determining the amount of current drawn.

    ReplyDelete
    Replies
    1. Indeed, it is the car always decides the current drawn, provided the charger has the ability deliver that current. Charger can decide to shutdown/delay/rampdown/up the charging at any point of time (that is the whole idea of smart charging). As far as I know, Fastned is not doing it, but gives an indication to their users to stop charging at around 80%.

      Delete
  2. 1. Does the charger set the charging speed of the vehicle or does the BMS of the vehicle. To my knowledge, there's a master/slave relationship between them, and a charger will never deliver more power than the vehicle (BMS) asks for. Or don't I get your point there?

    2. wasn't aware the towards the EOL the upper buffer of the operational SOC diminishes that much. 😦 do you have any good source where I can read more about this?

    ReplyDelete
    Replies
    1. Andi Piftor, MBA Yes, you're correct, it's the EV which decides the max charging rate; not the charging station. I didn't mention that as well. But, remember the charging station has the ability to 'stop charging' without the permission from the EV, that is what is happening here.

      2. There are many technical papers in the battery research shows clear margins, but none of those reports seem to available for free share. This blog has many articles discussing these margins. www.batteryuniversity.com/learn/article/electric_vehicle_ev

      Delete
  3. I foresee a battery scandel in the making ;)

    It's all about understanding the logic behind it and creating the expected behaviour for the end users. Keep up the good work Pon.

    ReplyDelete
    Replies
    1. Indeed, it is a trick. You won't believe, Chevy Volt operates the battery packs only between 20-60% of the actual capacity; rest all it's buffer!

      Delete
  4. Max charge rate changes continuously throughout state of state. Above 80-90% it slows to a trickle. At that rate its usually a waste to continue charging.

    If you look online you can find some charts, basically the charge rate curves down as the soc curves up.

    ReplyDelete
  5. Some have time limits. Some cutoff when current drops below a certain point.

    The idea with DCFC is not 100% charge, but fast charge as many cars as possible, and move along.

    After 90%, most EV will charge at a rate about the same as L2. The the fees are time based, you may be better off using L2 if you really need 100%.

    ReplyDelete
  6. Some stop at 80%, some at 92%, some at 100%. It's to decrease the time spent at the charger, to make it more available.

    ReplyDelete
    Replies
    1. Indeed, you may not believe, Chevy Volt operates the battery packs only between 20-60% of the actual capacity; rest all it's buffer!

      Delete

Powered by Blogger.